This will also copy the bad sector table and the new disk will treat the same sectors as bad even though they are normal. If this occurs, you should consider moving the data and replacing the disk.ĭo not use a block-level copy to transfer the data. If the number of bad clusters detected by dynamic bad-cluster remapping is too high, you cannot shrink the partition. For example, if you need to shrink the partition further, you can use Control Panel to move the paging file or stored shadow copies to another disk, delete the stored shadow copies, shrink the volume, and then move the paging file back to the disk. In some cases, you can relocate the file temporarily. When you provide the querycluster parameter, the command output will identify the unmovable file that is preventing the shrink operation from succeeding. If you know the cluster(s) associated with the file that is preventing the shrink operation, you can also use the fsutil command at a command prompt (type fsutil volume querycluster /? for usage). If the shrink operation fails, check the Application Log for Event 259, which will identify the unmovable file. When you shrink a partition, certain files (for example, the paging file or the shadow copy storage area) cannot be automatically relocated, and you cannot decrease the allocated space beyond the point where the unmovable files are located. If you do not specify a desired or minimum size, the command will reclaim the maximum amount of space possible. The minimum amount of space, in megabytes, to recover to the current partition. The amount of space, in megabytes, to recover to the current partition. If the partition includes unmovable files (such as the page file or the shadow copy storage area), the volume will shrink to the point where the unmovable files are located. Shrinks the volume with focus to create unallocated space. On a basic disk, selecting a volume also gives the corresponding partition focus. You can specify the volume by number, drive letter, or mount point path. If no volume is specified, the select command lists the current volume with focus. Selects the specified volume, where volumenumber is the volume number, and gives it focus. Shrinks the selected volume to desiredsize in megabytes (MB) if possible, or to minimumsize if desiredsize is too large.ĭisplays a list of basic and dynamic volumes on all disks. Selects the simple volume volumenumber you want to shrink.Īt the DISKPART prompt, type shrink. Note the number of the simple volume you want to shrink.Īt the DISKPART prompt, type select volume. To shrink a basic volume using a command lineĪt the DISKPART prompt, type list volume. You can only shrink basic volumes that have no file system or that use the NTFS file system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |